Knowing how to construct non-geometric, manufacturable shapes in CAD is essential since not all designs are rectangular boxes. This course, Onshape Essentials: Revolves, Sweeps, and Lofts, will teach you how to create shapes in Onshape that can't be bound by four corners. The Revolve, Sweep, and Loft features are powerful tools used to construct these non-geometric shapes, and you'll learn to use them here. Through this course you will also build a multi-part electrical controller that has complex wire routings and transitions. Finally, you will construct intricate features combining the skills learned in each module. In the end, your knowledge gained from this course will allow you to be a more accomplished and valued CAD designer. Required Software: Onshape.