Professional High Poly Modeling Tips in Maya LT

—Introduction and Project Overview 1m 4s

—Viewing Reference Model 1m 14s
—Modeling the Barrel 10m 56s
—Finishing the Barrel 9m 47s
—Modeling the Casing Top 11m 45s
—Refining the Casing Top 11m 41s
—Finalizing the Casing Top 10m 25s
—Creating a Hex Bolt 10m 22s
—Increasing Edge Flow to Speed up Workflow 10m 17s
—Creating the Cannon Casing 11m 21s
—Refining the Casing Underside 5m 19s
—Refining Shapes for Casing 9m 6s
—Using Floating Geometry 11m 41s
—Creating the Side Panels 10m 47s
—Refining the Side Panels 10m 21s
—Creating Casing Rear Connection 10m 44s
—Finishing the Rear Connection 10m 27s
—Completing the Barrel Underside 9m 52s
—Editing the Side Panels 9m 30s
—Finalizing the Side Panels 10m 42s
—Creating the Winch Base 11m 2s
—Refining the Winch Base 11m 31s
—Adding the Winch Connection 7m 9s
—Creating the Threaded Section of Winch 10m 13s
—Finalizing the Winch 10m 5s
—Blocking out Metal Panels 8m 35s
—Creating the Upper Panels 10m 0s
—Creating the Panel Connection 8m 58s
—Finalizing the Panel Connection 11m 40s
—Creating the Metal Pipes 10m 45s
—Completing the Metal Pipes 10m 7s
—Refining the Panel Connection 7m 3s
—Creating the Front Wheel 9m 10s
—Building the Lower Wheel 6m 46s
—Creating the Inner Panel 9m 9s
—Finalizing the Inner Paneling 9m 15s
—Pulling Together Tank Track 10m 23s
—Refining the Tank Track Rear Connection 6m 37s
—Blocking out Remaining Geometry 10m 25s
—Finishing the Tank Track Rear Connection 10m 56s
—Building the Tank Track Back Wheel 9m 27s
—Creating the Last Wheel 7m 26s
—Building a Tank Track Link 8m 5s
—Using CV Curve Tool for Tank Tracks 9m 48s
—Finishing the Tank Tracks 7m 6s
—Adding Inner Panel Details 10m 49s
—Creating the Base 6m 34s
—Creating the Rear Cannon 10m 36s
—Refining the Rear Cannon 10m 40s
—Finalizing the Rear Cannon 11m 59s
—Adding the Rear Hatch 5m 37s
—Finalizing the Howitzer 4m 35s